oil filter still leaking

Anonymous · Post by **Anonymous** » Sun Aug 14, 05 10:26 am

You hard northereners, you just dont care do you!!

Alex · Post by **Alex** » Sun Aug 14, 05 10:34 am

nope! wrench it up, fire it up, light em up

Anonymous · Post by **Anonymous** » Sun Aug 14, 05 11:03 am

CP has just told me the same. YES SIR!

latil · Post by **latil** » Sun Aug 14, 05 9:49 pm

Well , do you need my bag of granules for all that oil on the floor? Is the ceiling oily? Hope U get it sorted,nothing worse than this sort of problem.

Bryan · Post by **Bryan** » Tue Aug 16, 05 6:56 am

have a look at this miles.

http://board.moparts.org/ubbthreads/sho ... =0#1913438

Anonymous · Post by **Anonymous** » Tue Aug 16, 05 11:34 am

Thanks Brian, ive torqued it up real tight with a correct gasket. I'm hoping to fire it later to-day and then i'll have somebody watching the filter area really closely.

Rich · Post by **Rich** » Tue Aug 16, 05 11:13 pm

WELL?????????Is it 8) or is it

.Or maybe just plain

Keep at it cocker,weve all been there with this type of problem.I have used a 90 degree take off but had to have an ali adaptor made to mate the 90 degree jobbie to the block,and have some O rings made to suit(which I have 8 spares of as there was a ?5.00 minimum charge so I said I`ll have a fivers worth and got 10)Can take pix if they may be of any use...

Anonymous · Post by **Anonymous** » Wed Aug 17, 05 7:54 am

Rich, thanks, i'll keep that in mind as I want to fit apair of 340 manifolds that I have. i'm going to mock them up on the old 318 engine and check whether there is a need for a right angle adaptor.

Got the motor to fire today but the battrey was struggling so i've taken it back to the shop for checking.