Page 1 of 1
Chassis tilter?? anyone seen this?
Posted: Mon Nov 13, 06 11:52 pm
by Anonymous
Maybe looking for a chassis tilter.
Anyone seen these before?
http://www.cjautos.org.uk/phdi/p1.nsf/s ... ent&part=5
Posted: Tue Nov 14, 06 7:36 am
by Anonymous
As shown in my piccy in your other thread, i built mine out of a couple of old builders trestles and some steel. Cost £50 and a couple of evenings work. Got the plans from an old copy of practical classics. Been used on quite a few cars now.
Posted: Wed Nov 15, 06 1:35 am
by Anonymous
do you have some pics or the plans mate?
I can make em no problem.
Cheers
Morgs
bodytilter
Posted: Wed Nov 15, 06 8:45 pm
by sidewaysjas
I have seen the CJ Autos tilter and it is very good. Trouble is the model strong enough for a charger is about a grand !
I would also be interested in plans on how to make one, PLEASE !!!!!
Jason
Posted: Wed Nov 15, 06 10:38 pm
by Anonymous
Dont have any plans, it wasn't that good!
This is the best pic i have. bit of 2.5 inch tube ans some 2 inch too. Reinforced the top with some box section and two supports for the front of the tube. Though you cant see it it the photos, i did fit stabilisers when i did the charger cos i got the centre of gravity a bit wrong.
The car specific bit consists of a 2x4 box section with the 2 inch tube in the centre, then various brackets to bolt to the shell. I always use the bumper mounts + 1 other to stabilise it.
To lock it in position, i drilled a couple of holes through the tubes and just used a 10mm bolt to lock it.
Just make sure your welding is good and that the tube goes THROUGH the 2x4 box section.
Make sense?