Moderator: Moderators
Anonymous
Post
by Anonymous » Thu Jun 18, 09 11:44 am
I'm looking at getting a pair of 7x15 Centrelines for the front of the Chally.
However the ones I want don't come in the 4" backspacing thats recommended.
They only come in 3 5/16" and 4 7/8" can anybody advise me if either of these are any good.
Cheers
John
Dave-R
Posts: 24752 Joined: Sun Apr 18, 04 11:23 pm
Location: Dave Robson lives in Geordieland
Contact:
Post
by Dave-R » Thu Jun 18, 09 12:36 pm
4 7/8ths is no good for sure. The other one might work but you will have to measure first to be sure. I suspect it will hit the wheel arch.
Anonymous
Post
by Anonymous » Thu Jun 18, 09 9:23 pm
3 5/16 should be fine , 4 7/8 seems a bit tight although you may get away with 215 60s on there.
Anonymous
Post
by Anonymous » Thu Jun 18, 09 9:53 pm
Cheers guys, I was thinking that I could use a small spacer with the 3 5/16 ones with hopefully 235 60x15's.
What do ya reckon
Dave-R
Posts: 24752 Joined: Sun Apr 18, 04 11:23 pm
Location: Dave Robson lives in Geordieland
Contact:
Post
by Dave-R » Thu Jun 18, 09 10:57 pm
The stock 15x7s had 4.5 backspace. More than that and the wheel edge will hit the UCA.
Anonymous
Post
by Anonymous » Thu Jun 18, 09 11:25 pm
i thought you were talking about a charger.
Dave-R
Posts: 24752 Joined: Sun Apr 18, 04 11:23 pm
Location: Dave Robson lives in Geordieland
Contact:
Post
by Dave-R » Fri Jun 19, 09 10:01 am
Six-Pack John wrote: Cheers guys, I was thinking that I could use a small spacer with the 3 5/16 ones with hopefully 235 60x15's.
What do ya reckon
That would give you LESS backspace?
Anonymous
Post
by Anonymous » Fri Jun 19, 09 11:52 am
Sorry Dave I meant spacers on the 4 7/8 size.
Dave-R
Posts: 24752 Joined: Sun Apr 18, 04 11:23 pm
Location: Dave Robson lives in Geordieland
Contact:
Post
by Dave-R » Fri Jun 19, 09 12:19 pm
Thought you did.
Yes that would work. TrevD could knock you up a pair of 1/2" spacers.
Watch the stud length does not get too short though.
Anonymous
Post
by Anonymous » Fri Jun 19, 09 10:23 pm
Nice one, I've got some spacers but I'll PM TrevD if none are the right size.
Thanks for all your help on this one, I'm off to order some wheels
Mick
Posts: 3070 Joined: Sun Apr 18, 04 10:55 pm
Location: Nottingham
Post
by Mick » Sun Jun 21, 09 10:45 pm
John
If you look on the thread i posted under wheel spacers, you'll see a pic of the ones Trev made me.
They are absolutely bang on.
Mick