trunk seal

Anonymous · Post by **Anonymous** » Sat Jun 20, 09 5:47 pm

any one no witch way round trunk seal goes on charger ,thanks----------------sorry about pics

Dave999 · Post by **Dave999** » Mon Jun 22, 09 10:39 am

flattest thinnest section is pressed to body

fatter flubbery section stands proud to take pressure from the closed lid...you get a better seal that way

i.e the bit that can make up for mis alignment and poor fitting lid or door always goes towards the panel that closes not the body

or it does in my world

mine was on backwards and never stayed on....its now correct..... but is different from yours

Dave

Dave999 · Post by **Dave999** » Mon Jun 22, 09 10:42 am

then again looking at ya photo

i'll admit i don't know with that

what are you putting it on? the lid

in which case i'll modify what i said

the thinner section goes against a bit where it won't have to move or deflect much and the think section sits proud to take up the slack when closed

well it does i my world

blaa blaa blaa

etc

scuse me

Dave