Clicking noise for 904 in any gear exept neutral?

Anonymous · Post by **Anonymous** » Sun Oct 10, 10 11:47 am

Got the Chally out due to the weather forecast and found it is making a clicking sort of noise when in gear more in reverse. Drives ok at first I thought it was the converter guard plate bent and being hit by the converter its that sor tof noise. Any ideas guys?

latil · Post by **latil** » Sun Oct 10, 10 12:10 pm

Propshaft UJ dry and breaking up?

Kev · Post by **Kev** » Sun Oct 10, 10 12:56 pm

Torque convertor bolts backing out?

latil · Post by **latil** » Sun Oct 10, 10 1:03 pm

Cracked flexplate?

Anonymous · Post by **Anonymous** » Tue Oct 12, 10 6:11 am

Checked converter bolts all nice and tight it makes the noise while not moving too so not ujs, someone suggested a broken drive plate?'blue Dunc any ideas

latil · Post by **latil** » Tue Oct 12, 10 7:49 am

It could be internal convertor problems or the pump. Most other faults are normally only heard while on the move.

DaveMadders · Post by **DaveMadders** » Tue Oct 12, 10 8:24 am

Crank thrust bearings worn allowing crank to walk backward and forward?? See if you can shove the crank in and out by the bottom pulley.... that would give a click/knock that comes and goes as the converter bolts touch and them back off.

Anonymous · Post by **Anonymous** » Mon Oct 18, 10 8:21 am

Thanks Guys I'll check these out