Page 1 of 1
Crankshaft hand turning
Posted: Sat May 31, 14 11:29 am
by cadboy
Does anyone know the socket size for the crankshaft nut on front of 340 engine?
I need to turn the engine by hand to check a few things.
I know it is bigger than 1"
Cheers Ali
Posted: Sat May 31, 14 1:34 pm
by challenger
ali, if its the same as big block i,m pretty sure you can get away with 30-32mm socket as long as its hexagon
Posted: Sat May 31, 14 3:01 pm
by MilesnMiles
32mm does the job as Jim said! must be hex. I've used one many times.
Posted: Sun Jun 01, 14 9:32 am
by cadboy
Cheers guys I'll try that.
Posted: Sun Jun 08, 14 1:02 am
by mike jones
28 mm for a 440 Source damper bolt 6 point socket
Posted: Sun Jun 08, 14 4:51 pm
by cadboy
All sorted now thanks got an 1-1/4 socket and turned the engine.