Fitting proportioning valve in brake line

Rebel · Post by **Rebel** » Tue Jun 07, 16 2:19 am

Hi all,
Do I have to fit the proportioning valve in the brake line that goes from the distribution block to the back of the car or, can I fit it in the rear line from the master cylinder ( the one that goes from the master cylinder to the distribution block ) ?

Pete · Post by **Pete** » Tue Jun 07, 16 7:57 am

I would install it after the proportioning valve and in the line that runs to the rear brakes. Not tried it the other way and it may work, but I would personally do it the other way. You can mount it so that you can adjust the bias from within the car.

Rebel · Post by **Rebel** » Wed Jun 08, 16 2:07 am

Thanks Pete