Mopar Muscle Association UK

My connector and wiring got a bit frazzled in the fire, the motor seems ok though.
Anyone got a connector with or without wiring? The bulkhead side of the connector would be great too.

Have you considered bypassing the block and just hardwiring both looms together? I would, cuts out the connection completely

I'll probably have to now Steve, i just liked the look of the original

NOS

here

https://www.ebay.co.uk/itm/NEW-66-76-Pl ... ctupt=true


All 3 both sides ...

bit spendy but Nice

Dave

Strewth £100!
Thanks Dave but I don't think I need it that badly

yeah i know

ridiculous init

but it is nice and new...

however

I think you need 3 durite 6 way spade connectors in male and female
the durite brand can be bolted down with tiny bolts or riveted ...see the little indents

take your current bulkhead connector
use a grinder to take off the current males

use small bolts to mount up the Durite males in place

put females on ends of wires

good as new but white

costs about 6 quid + time and a filed down electricians screw driver for pinging connector tags +lots of jam jar labels and a pen

mask off spray the lot black

nobody knows

Dave

db wrote: Mon Mar 11, 19 12:21 am I'll probably have to now Steve, i just liked the look of the original

You can keep original looking if you very carefully drill out the relative holes in the connector and run each wire through its designated hole. Bit fiddly but a decent 'last resort' if needed. Good luck with this project

Cheers Steve

Cheers guys!