Chassis tilter?? anyone seen this?

Anonymous · Post by **Anonymous** » Mon Nov 13, 06 11:52 pm

Maybe looking for a chassis tilter.
Anyone seen these before?
http://www.cjautos.org.uk/phdi/p1.nsf/s ... ent&part=5

Anonymous · Post by **Anonymous** » Tue Nov 14, 06 7:36 am

As shown in my piccy in your other thread, i built mine out of a couple of old builders trestles and some steel. Cost £50 and a couple of evenings work. Got the plans from an old copy of practical classics. Been used on quite a few cars now.

Anonymous · Post by **Anonymous** » Wed Nov 15, 06 1:35 am

do you have some pics or the plans mate?
I can make em no problem.
Cheers
Morgs

sidewaysjas · Post by **sidewaysjas** » Wed Nov 15, 06 8:45 pm

I have seen the CJ Autos tilter and it is very good. Trouble is the model strong enough for a charger is about a grand !

I would also be interested in plans on how to make one, PLEASE !!!!!

Jason

Anonymous · Post by **Anonymous** » Wed Nov 15, 06 10:38 pm

Dont have any plans, it wasn't that good!

This is the best pic i have. bit of 2.5 inch tube ans some 2 inch too. Reinforced the top with some box section and two supports for the front of the tube. Though you cant see it it the photos, i did fit stabilisers when i did the charger cos i got the centre of gravity a bit wrong.

The car specific bit consists of a 2x4 box section with the 2 inch tube in the centre, then various brackets to bolt to the shell. I always use the bumper mounts + 1 other to stabilise it.

To lock it in position, i drilled a couple of holes through the tubes and just used a 10mm bolt to lock it.

Just make sure your welding is good and that the tube goes THROUGH the 2x4 box section.

Make sense?

Mopar Muscle Association UK

Chassis tilter?? anyone seen this?

Chassis tilter?? anyone seen this?

bodytilter