Water pump housing again

[Mick]

I am fitting an alloy rad and decided to repaint the waterpump and pulleys in the light blue to match the motor.
I would like opinions on my plan of attack, shot blast housing and pulleys then spray them, what paint should i use, considering it will get warm, it will have to be either brush or spray can.
Would aerosol, be OK, if so, i can get some mixed to the right colour.
Mick

[TrevD]

if you have a bit of paint to match go to any halfords , they can mix N match loads of colours. as for preperation use a good etching primer ( i use por8) and then the top coat . this will do most engine components with no problems, block heads inlet etc.

[Mick]

Is the heat of the housing a factor or not, with an aerosol.

[dustymopar]

The link below might be useful......

http://www.frost.co.uk/item_Detail.asp? ... %20(473ml)

At the bottom of the page is the colour you require

Wear gloves is you paint this stuff!! - is doesnt come of quick once its gone off