Hot Fuel?

Moderator: Moderators

Post Reply
Anonymous

Hot Fuel?

Post by Anonymous »

Have no idea what area this should be posted in so will try here! I have a black 69 charger 440 R/T vaguely stock, 284/484 cam, holley 750 with edelbrock performer intake. New ignition coil.Keep up that may be important, have a new fuel tank, new fuel filters one before and one after the fuel pump (don't know why but it was like that when I got it!).
Thursday and today whilst driving it has cut out completeley and died. Engine stops dead, there is no stuttering or spluttering, just a complete shut down the same as if you turn the ignition off.
All levels are fine, oil is 50psi or thereabouts at idle and upto 75 under acceleration.
Any suggestions? Have been told that it could be the engine block boiling the fuel in the pipe and causing a vapour lock? Fuel pipe is standard and doesnt feel hot to the touch, it is warm but then most things get warm under the hood. Fuel mixture may be slightly rich and I do get pinking, ignition is pretty retarded (like the owner!).
User avatar
Jon
Posts: 1874
Joined: Sun Apr 18, 04 11:06 pm
Location: Preston

Post by Jon »

that sounds more like ignition to me, vapour lock tends to splutter to a halt, at least it did when I had it
and the fuel lines would feel hot if the fuel was boiling
Anonymous

Post by Anonymous »

as I was wording it, that suggested it to me as well. Wonder if I should see about moving the coil from the intake manifold to elsewhere? Or maybe rewiring it with thicker wire.
Thanks for the speedy response BTW :D
User avatar
Dave-R
Posts: 24752
Joined: Sun Apr 18, 04 11:23 pm
Location: Dave Robson lives in Geordieland
Contact:

Post by Dave-R »

If it was fuel boiling it would happen when trying to start the car hot. Sounds electrical to me.

Easy to tell if it was fuel. When it stops like that look in the carb to see if it has fuel in.

There is a small chance on the fuel front. If you are sure both filters are OK there is (or should be) another filter in the tank on the end of the sender. Sometimes they can get blocked. No-one ever thinks to replace those.

To tell if it is electrical check for spark at the plugs.

If no spark there check at the coil. Sometimes the coil to dizzy lead can break and kill spark to all plugs.

If no spark at the coil you have a wire off somewhere. If you have points in the distributor....get a life. :wink:

BTW if you are wondering where you should have posted this you should have gone into "Engine, Carburation & Electrics". The clue in in the title see. :P :wink:
Anonymous

Post by Anonymous »

Cheers for that Dave the more I think (the more it hurts) the more I think it must be electrical, Especially as after a couple of minutes it is fine.
Guess that means I need to actually fit the new leads rather than keeping then neatly in the boot huh? :lol:
Right shall swop them over tomorrow and see what happens.
Cheers Guys :)
User avatar
Alex
Posts: 4817
Joined: Thu Apr 15, 04 10:20 pm
Location: 53 deg 45' N, 2 deg 32' W (Manchester)

Post by Alex »

If you have a tach go for a run until it cuts and watch the tach, if it drops as the engine cuts it is electrical, it the tach stays up as you coast it is fuel.
Guy
Posts: 5002
Joined: Sun Apr 18, 04 10:20 pm
Location: Behind a Camera

Post by Guy »

The car has electronic ignition .
User avatar
Bryan
Posts: 972
Joined: Sun Apr 18, 04 11:27 pm
Location: Woking, Surrey

Post by Bryan »

bulkhead connector?
1968 Ford Fairlane 500 Wimbledon White. Currently a 302 auto but to be 410 4 speed.
Anonymous

Post by Anonymous »

So general concensus is electrical, thought the fuel and vapour lock was a bit far fetched. Will replace all the ignition leads (about time I fitted them!) and then chase all the wires back from the ignition coil, repairing and/or replacing. If nothing else it will look tidier :lol:
Cheers for the input guys - appreciated.
Post Reply