Wheel studs

Birdman · Post by **Birdman** » Sat May 23, 09 7:22 pm

I have some new alloys with unilug spacing,but, need to get alloy wheel lugs. Can I replace the wheel studs from the 7/16 RH front ( discs) and the 7/16 RH/LH combo ( drums) with 1/2 RH? Where is the best place to source the studs? Any help from all you knowledgeable guys would be appreciated.
Cheers
Chris

Anonymous · Post by **Anonymous** » Sat May 23, 09 7:28 pm

TIM @ Raceways of Donington FELLA

01283 517935

TrevD · Post by **TrevD** » Sat May 23, 09 8:27 pm

not all studs are the same, i produce billet ali hubs and the company i manufacture them for supply the studs (all 1/2" unf) the part that presses into the hub isnt always the same (0.04" or 1mm different) so be carefull what you buy, they need to be a good press fit in the hub.

Birdman · Post by **Birdman** » Sat May 23, 09 9:48 pm

Thanks for the advice guys, this is exactly why I asked for help; these things can be a bit of a minefield, so to speak.