8-3/4 rear
Moderator: Moderators
-
moparnutterz
- Posts: 332
- Joined: Fri Mar 16, 07 9:24 pm
- Location: Preston, Lancashire
8-3/4 rear
Ive got an 8-3/4 on the back of the dodge. I fitted an aubern lsd two years ago, I have just fitted green bearings on the shaft and the diff now feels very tight, the car was very hard to push at shakie, anybody any ideas, cheers Dave
I've read that you may have to remove the thrust button from inside the suregrip when green bearings are fitted, it's only needed with the tapered bearings. Mine is still fitted and I fitted green bearings years ago. Did the flange on the second half shaft you fitted push right up to the diff ok? If it didn't and you pulled it up with the nuts you may be crushing the bearings.
-
moparnutterz
- Posts: 332
- Joined: Fri Mar 16, 07 9:24 pm
- Location: Preston, Lancashire
post subject
Cheers Mick, I reckon your right, been having a read, going to pull the diff next Saturday, will post back 
