Fluid all over my crazy paving :(

Anonymous · Post by **Anonymous** » Thu Jul 08, 04 10:17 pm

Like you Im a bit of a worrier too

I wasnt sure if you could get a trans temp gauge. Id also like to get a fuel pressure gauge as when I was running up the engine after sorting out all the cooler lines, the fuel pipe decided to split and do a "crazy snake" spitting fuel eveywhere. God only knows what would have happened if the hood was still on and Id been driving

Just wanted to know a good place for gauges and piping etc

Anonymous · Post by **Anonymous** » Thu Jul 08, 04 11:07 pm

Heres whats left of the old pipes!

Dave-R · Post by **Dave-R** » Fri Jul 09, 04 8:18 am

I get all my stuff from Summit Racing.

Blue · Post by **Blue** » Fri Jul 09, 04 9:04 am

Markie, I think I've got a trans temp gauge if you want one. I like to keep gauges to a minimum, if I had gauges monitering everything it would just give me more to worry about!

Anonymous · Post by **Anonymous** » Fri Jul 09, 04 2:57 pm

Im interested Blue.. how much do you want for it?

Blue · Post by **Blue** » Fri Jul 09, 04 4:16 pm

I'll get back to you after the weekend Markie, I'll just make sure I've still got it and the sender unit and stuff. It fits into one of the cooler lines, what size lines do you have on there now?

Dave-R · Post by **Dave-R** » Fri Jul 09, 04 10:10 pm

You can use any water type temp sender. Normal practice is to weld a nut to the pan and screw it in there.

Anonymous · Post by **Anonymous** » Sat Jul 10, 04 4:39 pm

Blue, I have 10mm lines on the car now.

Dave, cheers for the tip but if I can get one that goes in line then Id prefer to keep the wiring away from under the car, better off in the engine bay. As you know on these cars the wiring is a bit suspect! Im lucky on mine as its been well looked after but one day...one day... Im going to replace all the wiring...