Nick Eagle 68 Roadrunner

Derek · Post by **Derek** » Tue Aug 17, 10 5:04 pm

You don't waste no time.

Anonymous · Post by **Anonymous** » Tue Aug 17, 10 5:05 pm

driver door wasnt to bad two small patches in both lower corners then more filling and painting to get both rear wing and door straight

Ivor · Post by **Ivor** » Tue Aug 17, 10 5:15 pm

Is that a ripple I see in that door?

Nope, thought not!

Anonymous · Post by **Anonymous** » Thu Aug 19, 10 11:40 am

Hiya Nick,

Just seen this thread, cant believe the Chevy's gone but wow what a fantastic replacement, an original post car

Cant wait to see the progress on this one mate, what are the plans? Colour, wheels etc?? or are you keeping it close to your chest for now??

Charger · Post by **Charger** » Thu Aug 19, 10 12:29 pm

fantastic stuff

, and great garage/workshop you have there

Rogue Trooper · Post by **Rogue Trooper** » Thu Aug 19, 10 6:35 pm

Another nice motor saved, keep the pic's coming

RobTwin · Post by **RobTwin** » Fri Aug 20, 10 2:07 am

Nick

Looks like you have the same problem areas we did a few years ago (20, to be precise

)

http://www.moparuk.com/forums/viewtopic.php?t=5764

We had to have the trunk extensions made to replace the rusty bits back then cos they werent being remanufactured.... hope you got yours replaced before welding the new quarter repair panels on

Anonymous · Post by **Anonymous** » Sun Aug 22, 10 8:10 pm

flippin eck nick at this rate that will be on the road before mine lol,looking good mate dont forget to give me a ring so i can come round eh

Anonymous · Post by **Anonymous** » Thu Aug 26, 10 7:07 am

boot was in great condition just a few high and low spots

Anonymous · Post by **Anonymous** » Thu Aug 26, 10 7:17 am

rear panel had two small patch panels roof was good

Anonymous · Post by **Anonymous** » Thu Aug 26, 10 7:29 am

underside of bonnet was grit blasted came up great two small pin holes repaired. front screen valance was rusted drivers side. cut out and welded a small patch, when the screens in it should be a ok repair.

Anonymous · Post by **Anonymous** » Thu Aug 26, 10 7:40 am

Nearside rear quarter panel and had 10mm of filler. the bottom of the door was rusted out and front of the rear quarter was the same

Anonymous · Post by **Anonymous** » Thu Aug 26, 10 7:48 am

door had a new lower skin repair patch from roc autos.

Anonymous · Post by **Anonymous** » Thu Aug 26, 10 8:03 am

cut out the rusted rear quarter

Anonymous · Post by **Anonymous** » Sat Aug 28, 10 10:31 am

Nick,

I have a brand new pair of the "L" shaped qtr molding gaskets for what I think are for a road runner that were shipped to me by mistake you can have