Hipo 340 exhaust manifold fit?

Anonymous · Post by **Anonymous** » Tue Oct 18, 05 7:15 pm

I had some problem attempting to fit an original 340 manifold to my 360 Dart sport (manifold part no. shows it to be 340-1968070 fittment) on the drivers side.
The manifold would not fit past the power steering column/brake master cylinder.
Has anyone else fited one of these in situ and is it usual to have to undo the engine mount and tilt the engine to fit the exhaust manifold?

Holly · Post by **Holly** » Tue Oct 25, 05 8:11 pm

I believe the hi-po cast manifolds are usually fitted off the car ... I bet someone's managed it though, lol.

Alex · Post by **Alex** » Tue Oct 25, 05 8:37 pm

They are a pain but do able LOL you may need to move the engine about..

Anonymous · Post by **Anonymous** » Tue Oct 25, 05 10:23 pm

Thanks chaps, i just needed to be sure. I assumed that being a factory fit they would just'bolt on'! Yeah, right

at least i can continue with the factory stock look now.

MilesnMiles · Post by **MilesnMiles** » Sun Nov 06, 05 11:06 am

Blimey, i'm not that boring!! When did get to be anonymous??

Holly · Post by **Holly** » Sun Nov 06, 05 5:32 pm

When I had to recreate your username so you get back on the board!

MilesnMiles · Post by **MilesnMiles** » Sun Nov 06, 05 6:39 pm

Cheers James, all I did was click on one of the new icons out of curiosity. Doesnt just kill cats then!

Holly · Post by **Holly** » Sun Nov 06, 05 6:53 pm

Wouldn't be a problem with the password