Crankshaft hand turning

cadboy · Post by **cadboy** » Sat May 31, 14 11:29 am

Does anyone know the socket size for the crankshaft nut on front of 340 engine?

I need to turn the engine by hand to check a few things.

I know it is bigger than 1"

Cheers Ali

challenger · Post by **challenger** » Sat May 31, 14 1:34 pm

ali, if its the same as big block i,m pretty sure you can get away with 30-32mm socket as long as its hexagon

MilesnMiles · Post by **MilesnMiles** » Sat May 31, 14 3:01 pm

32mm does the job as Jim said! must be hex. I've used one many times.

cadboy · Post by **cadboy** » Sun Jun 01, 14 9:32 am

Cheers guys I'll try that.

mike jones · Post by **mike jones** » Sun Jun 08, 14 1:02 am

28 mm for a 440 Source damper bolt 6 point socket

cadboy · Post by **cadboy** » Sun Jun 08, 14 4:51 pm

All sorted now thanks got an 1-1/4 socket and turned the engine.