Used to be Blue's Valiant

shovelheadrob · Post by **shovelheadrob** » Fri Oct 23, 15 7:45 pm

Pete wrote:Looking very cool

Rod operated as usual, I see.

My money is on a tube, like a rod but with a hole in the middle

Pete · Post by **Pete** » Fri Oct 23, 15 7:56 pm

I'm sure it will be very light - it is probably like a lot of holes all lined up together.....

lough3969 · Post by **lough3969** » Fri Oct 23, 15 9:52 pm

What guage do you have on exterior of the screen Blue? Loving that throttle linkage...

Blue · Post by **Blue** » Sat Oct 24, 15 12:47 am

Of course it's tube, aluminium tube. That's a Stewart Warner fuel pressure gauge Dorian, ready for when I sort out the fuel system.

pete walton · Post by **pete walton** » Sat Oct 24, 15 9:20 am

Ramtastic

Blue · Post by **Blue** » Wed Nov 04, 15 6:47 pm

Mounts welded on, painted, lightweight rear cover, prop is here, time to chuck it back under the car...

shovelheadrob · Post by **shovelheadrob** » Wed Nov 04, 15 7:07 pm

Have you been raiding Will's paint dept?

GJUK · Post by **GJUK** » Wed Nov 04, 15 7:22 pm

Roger · Post by **Roger** » Wed Nov 04, 15 8:56 pm

shovelheadrob wrote:Have you been raiding Will's paint dept?

I was thinking that!

Great work as usual

Blue · Post by **Blue** » Thu Nov 05, 15 6:22 pm

Just the brakes to assemble now and we're all done at this end.

Steve · Post by **Steve** » Thu Nov 05, 15 6:48 pm

Looks great Blue....very subtle....please take note Will....no glitter in the paint!

RobTwin · Post by **RobTwin** » Fri Nov 06, 15 8:28 am

Steve wrote:....no glitter in the paint!

obviously - less weight!

Blue · Post by **Blue** » Fri Nov 06, 15 8:35 am

Clearly I would only use aluminium or titanium glitter....

Cannonball · Post by **Cannonball** » Sat Nov 07, 15 6:47 pm

Lik,in it bluester,,

looks very old school with the upright shox,

Blue · Post by **Blue** » Sat Nov 14, 15 2:57 pm

Tunnel ram bead blasted and rest of the installation finished off, just need to re jig the plug leads so the tach drive cable has a bit more clearance. Front panel and doors with Dale the fibreglass to take moulds off, he's mad busy at the moment but I should have 'em back by March

Back axle all done, bled and adjusted, new shorter handbrake cables fitted, new 1350 prop installed with billet yokes. I'll sort out the exhaust next I think...