Propshaft boot

Bryan · Post by **Bryan** » Mon Jan 25, 16 11:02 pm

A guy has asked the following on Facebook. Any ideas??

Quick question for any Mopar people on here,I need a propshaft boot for my '63 Chrysler 300.. anyone in the UK likely to stock them,is it a case of order from the States or has anyone used a steering rack CV boot or similar that does the job?

steveo · Post by **steveo** » Mon Jan 25, 16 11:36 pm

yes ive seen that propshaft , before , it has a rubber gator covering the front UJ , instead of the normal slip yoke , , think a trip to a local motor factors would do , have a measure up , may be a universal cut to fit one .
there is a similar type of boot from memory on a capri 28 injection prop , on the front , of the rear section where it connects to the constant velocity joint , not saying this will fit , but , its similar sort of set up , cant take a picture , long since sold all my two eight I capris

edit found a picture on ebay of said capri prop , incase anyone was wondering what I was waffling on about

Super Sloth · Post by **Super Sloth** » Mon Jan 25, 16 11:38 pm

I would suggest calling up a prop specialist with some dimensions would be the best bet. They are likely to have stuff like that sitting on the shelves.
Try GKN drivelines? I've used them in the past and found them helpful and efficient.

latil · Post by **latil** » Tue Jan 26, 16 8:34 am

It's a CV type joint so a universal gaitor kit might go on there.

Dart Vader · Post by **Dart Vader** » Tue Jan 26, 16 7:38 pm

try propshaft services in Feltham

Bryan · Post by **Bryan** » Tue Jan 26, 16 11:03 pm

Cheers lads. I have passed on all your suggestions.

Dave999 · Post by **Dave999** » Wed Jan 27, 16 10:29 am

http://www.ebay.co.uk/itm/Mopar-Drive-S ... 1707762456?

orginal styleeeeeee

I think

but it is in the states

Dave

latil · Post by **latil** » Wed Jan 27, 16 10:48 am

That is the small one,there's two sizes. Double check first.