BUMPER

Jem · Post by **Jem** » Mon Dec 03, 07 5:39 pm

Does anyone know of someone who can straighten a steel bumper? It's
slightly bent on the bottom of the off side leading edge. It's a mild curve, not a dent.

Anonymous · Post by **Anonymous** » Mon Dec 03, 07 6:37 pm

give JPC a bell?

Jeff · Post by **Jeff** » Mon Dec 03, 07 6:48 pm

There used to be a place in Tottenham Jem..... Somewhere near Lordship Lane.

Jem · Post by **Jem** » Mon Dec 03, 07 6:51 pm

Cheers chaps. Tottenham isn't too far at all - please let me know if you remember the name Jeff.

latil · Post by **latil** » Mon Dec 03, 07 6:53 pm

All depends how bad it is,all I ever use is angle iron or thick timber wrapped in an old blanket and some heavy duty G clamps.

Adam · Post by **Adam** » Mon Dec 03, 07 7:08 pm

About 25 years ago, I tried tapping a bent corner straight by reversing gently into a brick wall. Knocked the whole wall down. Hope Adur District Council aren't reading this...

Blue · Post by **Blue** » Mon Dec 03, 07 7:18 pm

It was Barwood's in Tottenham, packed up years ago, site soon to be cleared for yet more flats...

Jem · Post by **Jem** » Mon Dec 03, 07 8:25 pm

Thought you would have been more subtle than that Adam - sounds like the sort of thing I'd do!

Like the idea of the G clamps - sounds like a plan does that!

Blue · Post by **Blue** » Mon Dec 03, 07 8:30 pm

Good idea latil, that might just work.....

Cannonball · Post by **Cannonball** » Mon Dec 03, 07 8:35 pm

take it you got the bumper then jem, i have just bought another rear one its not as good as your one though

latil · Post by **latil** » Mon Dec 03, 07 10:24 pm

My method worked on the Fury loop bumper,it was bent back about 1 1/2" on the offside. When I got the car it had a hard smack that side which had put the back edge of the wing through the windscreen. At least i didn't have to ship one over.

Mopar Muscle Association UK

BUMPER

BUMPER

Bumper

bumper